精品视频在线观看专区,饥渴老熟妇乱子伦视频,五月天综合婷婷综合社,国产精品美女久久久久久小说

江蘇春晨電纜有限公司：http://www.hg0881.cn/st161256/

With the application of editing YC cable rubber sheathed cable and submersible pump: it is mainly used for supporting the submersible motor, type JHS, JHSB.

無線電裝置用電纜：目前主要生產兩種橡套電纜(一種屏蔽的,一種不屏蔽)，基本能滿足要求，型號為WYHD，YC。

Cable for radio equipment: at present, the main production of two kinds of rubber sheathed cables (a shield, a shield), the basic can meet the requirements, models for WYHD, YC.

攝影用電纜產品：配合新型光源的發展，具有結構小、性能好，同時滿足室內和野外工作的需要，逐步取代一些粗重、耐熱性能差的老產品。

Cable product photography: combined with the development of new light source, has the advantages of small structure, good performance, and meet the needs of indoor and field work, gradually replaced the heavy and poor heat resistance of old products.YC橡套電纜

yc橡套電纜分類編輯 橡套電纜分為重型橡套軟電纜（YC電纜，YCW電纜），中型橡套軟電纜（YZ電纜，YZW電纜），輕型橡套軟電纜（YQ電纜，YQW電纜），防水橡套軟電纜（JHS電纜，JHSB電纜），電焊機電纜（YH電纜，YHF電纜）YHD電纜為野外用鍍錫電源連接線。YC橡套電纜

YC classification edit rubber sheathed cable rubber sheathed cable is divided into heavy cabtyre cable (YC cable, YCW cable), medium soft rubber cable (YZ cable, YZW cable), light soft rubber cable (YQ cable, YQW cable), waterproof rubber sheathed flexible cable (JHS cable, JHSB cable). Electric welding machine cable (YH cable, YHF cable, YHD cable) with tinned power cable field.

yc橡套電纜修補措施編輯 一、設備：具有自動控溫、定時和多規格管狀模腔的小型壓力設備。

YC rubber sheathed cable repair measures, a editing equipment: small pressure equipment with automatic temperature control, timing and sizes of tubular cavity.

二、膠料：與所補電線的線材*，并且含膠量要高于被補材料，硫化體系略強。

Two, rubber material: with the wire of the wire is consistent, and the amount of glue to be higher than the material, curing system is slightly stronger.

三、操作方法：

Three, operation method:

1、按照膠料的硫化體系設定溫度和時間

1, according to the curing system of rubber material set temperature and time

2、用橡膠用油墨稀釋劑檫洗修補處，特別是結合處要充分處理。

2, with a rubber ink diluent washing repair, especially where the full treatment.

3、根據缺口的大小適量剪取修補膠料，注意不能偏多或偏少，

3, according to the size of the amount of their gap repair adhesive material, not too much or too few,

4、將剪好的膠料塞在缺口處，，注意膠料不要高于電線圓周面。

4, cut a good rubber plug in the gap, and pay attention to the rubber material is not higher than the surface of the wire.

5、用耐高溫PP帶包好。并將其放入比線徑略小的管狀模腔里，鎖緊上下模，讓所補位置具有一定的壓力。注意模腔直徑比線徑略小0.1~0.2mm。

5, with high temperature resistant PP with a package. And put it into the tubular cavity is smaller than the line size in the lock on mode, make up position has a certain pressure. Note the cavity diameter is smaller than the diameter of 0.1~0.2mm.

6、待硫化時間到，取出產品，如有少量膠料溢出，用鋒利刀片修盡，并用稀釋劑檫盡即可。

6, the curing time to remove the product, if a small amount of glue overflow, with a sharp blade repair, and can make thinner sassafras.

四、驗證方法：

Four, verification method:

將適量空氣壓入所補電線并置于水中，見有無漏氣現象即可判定好壞。

The right amount of air into the wire and put it into the water, see whether there is no leakage phenomenon can be judged good or bad.